Bathroom Remodeling in Silverdale, WA
Full gut or a lighter refresh. Tile, shower, vanity and layout, done by licensed local remodelers. Typical price here: $18,300 – $39,100.
What to know before you hire in Silverdale
Most homes in Silverdale went up around 1992, which means builder-grade fiberglass tubs, cultured-marble tops and almond fixtures are now 25 to 40 years old. The plumbing is usually fine, so the money goes into tile, the shower and the vanity rather than repairs.
Expect roughly $18,300 – $39,100 for a mid-range remodel in Silverdale. Local labor rates and home values put the area about 22% above the US average.
Timeline: 3 to 6 weeks of work for a typical hall or primary bath, plus 1 to 4 weeks before start for design, permits and material lead times.
Estimate your bathroom remodel cost
Adjusted for labor and housing costs in Silverdale.
Project level
Source: U.S. Census Bureau, American Community Survey 5-year estimates.
Bathroom Remodeling cost in Silverdale
Installed price ranges adjusted for Silverdale labor and housing costs. Your quote depends on size, condition and the products you choose.
Refresh
Same layout. New vanity, toilet, fixtures, lighting, paint and a tub or shower surround.
Mid-range remodel
Down to studs. New tile floor and shower walls, tub-to-shower conversion, fan, updated supply lines.
Upscale primary bath
Layout changes, curbless shower, double vanity, heated floor, custom glass and stone.
Cost breakdown
| Line item | Typical range |
|---|---|
| Demolition and disposal | $1,200 – $3,700 |
| Plumbing rough-in and valves | $1,800 – $6,700 |
| Tile (floor and shower walls), installed | $3,100 – $11,600 |
| Shower pan, waterproofing, niche | $1,100 – $3,900 |
| Vanity, top and faucet | $1,500 – $7,300 |
| Toilet, installed | $400 – $1,700 |
| Glass shower door / enclosure | $1,100 – $4,300 |
| Electrical, lighting, exhaust fan | $1,000 – $3,700 |
| Drywall, paint, trim | $900 – $2,700 |
| Permit and inspections | $200 – $1,500 |
Popular options
- Tub-to-shower conversion. The most requested change. Typically $7,000 to $16,000 with tile, less with an acrylic or solid-surface system.
- Curbless / walk-in shower. No step in, linear drain, often with a bench and grab bars. Good for aging in place and small rooms.
- Heated tile floor. Electric mat under tile, about $10 to $20 per sq ft installed. Popular in colder climates.
- Large-format porcelain. Fewer grout lines, less scrubbing. The floor has to be dead flat, so prep runs a bit higher.
Free bathroom remodel quote in Silverdale
A licensed installer who works in Kitsap County will measure and price it. No obligation.
Choosing an installer in Silverdale
Contractors must register with the Washington Department of Labor & Industries and carry a bond.
- Verify the license or registration on the state lookup and match the name on the estimate.
- Ask for a certificate of general liability insurance and workers' comp, sent directly from the insurer.
- Get a written, line-item estimate: demo, plumbing, waterproofing, tile, fixtures, permit.
- Ask who pulls the permit. It should be the contractor, in their name.
- Ask which waterproofing system they use behind tile and whether it carries a warranty.
- Keep the deposit modest and tie later payments to finished milestones, not dates.
- Get labor and product warranties in writing before work starts.
How it works
In-home measure and scope
The remodeler checks the subfloor, venting, supply lines and drain locations, then writes a line-item scope.
Design and selections
Pick tile, vanity, fixtures and glass before demo starts. A back-ordered vanity can stall the job for weeks.
Permit
Most cities require a permit when plumbing, electrical or walls change. Your contractor should pull it in their name.
Demo, rough-in, inspection
The room is opened up, plumbing and electrical are roughed in and inspected before walls close.
Waterproofing and tile
A bonded membrane or liquid waterproofing goes on before tile. Skimp here and the shower fails in 5 years instead of 30.
Finish and final walkthrough
Vanity, toilet, glass, trim and paint, then final inspection and a punch list walk with you.
ZIP codes served
Nearby towns
Other towns in Washington
More bathroom services in Silverdale
Questions from Silverdale homeowners
How much does a bathroom remodel cost in Silverdale?
Most Silverdale homeowners pay $18,300 – $39,100 for a mid-range remodel. A cosmetic refresh starts around $7,900, and a large primary bath can reach $97,700. Local prices run about 22% above the US average.
Does a bathroom contractor in Silverdale need a license?
Contractors must register with the Washington Department of Labor & Industries and carry a bond. Also check with the Kitsap County building department about permits for plumbing or electrical changes.
Which ZIP codes in Silverdale are served?
Installers in our network cover 98315, 98383. If you live just outside them, call anyway. Most crews drive 20 to 40 miles for a job.
How long does it take?
Plan on 3 to 6 weeks of on-site work once demo starts. The schedule usually depends on the plumbing inspection and on special-order items like glass and vanities.
Do I need a permit?
Usually yes if plumbing, electrical, framing or ventilation changes. Swapping a vanity or toilet in the same spot usually does not. The contractor should pull the permit. If they ask you to pull it as the owner, that is a red flag.
Does a bathroom remodel add value?
At resale, a mid-range bath remodel usually gets back somewhere around two-thirds of what it cost, depending on the market. The bigger effect is speed of sale: buyers walk away from dated or water-stained bathrooms, and they notice the shower and vanity first.